Installation manual

FuelMaster
®
Installation Manual
142
5. Press Y to save the configuration changes. The configuration changes will be recorded and a display
similar to the following should appear:
SAVING SYSTEM CONFIGURATION…
CONFIGURATION RECORDED.
Enter Pump Pricing: for pump pricing for a credit card transaction to be effective, it must be sent to
the FMU. Very Important! Refer to the FMPlus User Manual to enter pump pricing. It is highly
recommended pump pricing be sent from the FuelMaster
®
software. If pump pricing is entered with a
laptop, and similar pricing is not loaded in the FuelMaster
®
software, credit card pricing may differ from
the cost reflected when transactions are downloaded to the Central Controller. Regardless of the pricing
entered at the FMU, the software will calculate pricing based on the pricing in the software. If a customer
asks our Customer Satisfaction Center (CSC) to enter pricing with a Procomm connection to their FMU,
the CSC must have a written request from the customer. When referring to the software manual, note
also pricing for Discount Credit Cards.
Display Last Transaction: It is a W&M requirement to display the total sale and quantity of the last
fueling transaction for at least 5 minutes (300 seconds), or until the next transaction is initiated. Where
needed or desired, FuelMaster
®
may be enabled to automatically show the last transaction on the display
of the FMU similar to the following example:
HOSE: 1 – 100LL
SALE: $51.60 17.20 GL
NOTE
The last transaction will display $0.00 until a 59 command and PRINT DOLLAR FOR PROKEE
RECEIPTS is ENABLED.
Perform the following to display the last transaction:
1. Type a 7D (or 7d) command, and press Enter. A display similar to the following should appear:
Weights & Measures: Display Last TX Configuration
----------------------------------------------------------------------
Command Interface: 7D, ARG1, #ARG2
ARG1 – Display Last TX: 0 Disable, 1 Enable
ARG2 – Timeout in Seconds (Optional: Default=300, 0=Indefinitely)
Current Configuration
Display Last Transaction: Disabled
2. ARG = argument. To enable the display of the last transaction, 7D, 1 must be entered (7D,0 would
disable the display). If the default 5 minutes (300 seconds) is desired, do not enter the second
argument. Enter only 7D, 1. A display similar to the following should appear:
CONFIGURATION HAS CHANGED!
WOULD YOU LIKE TO SAVE IT ? (Y/N)
3. Press Y to save the configuration changes. The configuration changes will be recorded and a display
similar to the following should appear:
SAVING SYSTEM CONFIGURATION…
CONFIGURATION RECORDED.
318