AT083A HP Fabric Clustering System PCIe 2-port 4X QDR Fabric Adapter Installation Guide HP-UX Integrity Server Networking HP Part Number: AT083-9000A_ed2 Published: February 2011 Edition: 2.
© Copyright 2011 Hewlett-Packard Development Company L.P Legal Notices The information in this document is subject to change without notice. Hewlett-Packard makes no warranty of any kind with regard to this manual, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose.
Table of Contents 1 HP PCIe 2-port 4X QDR Fabric Adapter Installation..................................................5 HP Fabric Clustering System Installation Prerequisites.........................................................................5 Install HP Fabric Clustering System Adapters.......................................................................................6 Installing the AT083A Host Channel Adapter .................................................................................
List of Figures 1-1 4 Inserting the Host Channel Adapter...............................................................................................
1 HP PCIe 2-port 4X QDR Fabric Adapter Installation This document gives installation information for the HP Fabric Clustering System Host Channel Adapter (HCA) for InfiniBand™, AT083A PCIe Adapter with 2 (two) 4X copper or fiber interfaces. NOTE: The AT083A card is NOT supported on PA systems. The AT083A product is for use in high-performance technical computing clusters and in database clusters.
• • • • • Check the cluster configuration plan for information on where to install adapters, switches, and cable guides, and where cables are to be routed. Check your server's documentation to see if additional tools may be required for component installation. For specific instructions on adapter installation, see system-specific documentation on "installing networking adapters" for each server that adapters will be installed into.
2. Install the card a. Slide the adapter edge-connector into the PCIe slot until it is fully seated. b. Secure the card and reassemble the system. Figure 1-1 Inserting the Host Channel Adapter 1 4X IB Interfaces 2 PCIe slot Install HP Fabric Clustering System Software This section describes the steps necessary to install HP Fabric Clustering System software. The same software version must be installed on each instance of the HP-UX operating system in the fabric. 1. 2. Log on to the system as root.
5. 6. 7. Change the Source Host Name, if necessary, and then enter the mount point of the drive in the Source Depot Path field. Select the OK button to return to the Software Selection window. The Software Selection window now contains a list of available software to install. Highlight the HP Fabric for InfiniBand software and choose Mark for Install from the Actions menu; this chooses the highlighted software.
FCC RFI Statement This device complies with part 15 of the FCC Rules for Class A Apparatus. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
