HP Smart Zero Core 4.4 Administrator Guide

Table C-6 root > ConnectionType > xen (continued)
Registry key Description
root/ConnectionType/xen/gui/XenManager/widgets/isInMenu
root/ConnectionType/xen/gui/XenManager/widgets/label
root/ConnectionType/xen/gui/XenManager/widgets/password
root/ConnectionType/xen/gui/XenManager/widgets/
username
root/ConnectionType/xen/gui/XenManager/widgets/
waitForNetwork
root/ConnectionType/xen/gui/fbpanel/autohide Whether to autohide the taskbar. Set to 'true' to autohide the
taskbar.
root/ConnectionType/xen/gui/fbpanel/edge The default position of the taskbar when more than one
published desktop or application is available.
root/ConnectionType/xen/gui/fbpanel/hidden Set to 1 to completely hide the taskbar. Can be hidden only if
autoStartResource or autoStartDesktop is enabled.
root > Display
This section describes the registry keys, functions, options, and descriptions in the root > Display
folder.
Table C-7 root > Display
Registry key Description
root/Display/Configuration/displaymode Specifies the display mode of the unit. A value of 0 denotes
standard mode (1–4 monitors), whereas a value of 1 denotes
a 6-monitor mode. The HP t610 with the appropriate add-on
card is the only supported hardware.
root/Display/Configuration/hexlayout
root/Display/Configuration/hexprofile
root/Display/Configuration/primaryprofile This must always be set to default.
root/Display/Configuration/quaternarymode
root/Display/Configuration/quaternaryprofile
root/Display/Configuration/quaternaryrelative
root/Display/Configuration/secondaryConnector
root/Display/Configuration/secondarymode If supported, specifies the position of the secondary monitor
relative to the primary monitor.
0—Same As
1—Above
2—Right Of
3—Left Of
4—Below
84 Appendix C HP Smart Zero Core registry settings