HP Slate8 Pro Maintenance and Service Guide

2.
Disconnect the following cables from the system board:
(1) WLAN main antenna cable (see
WLAN antenna on page 23)
(2) WLAN auxilliary antenna cable (see
WLAN antenna on page 23)
(3) Microphone ZIF cable and connector (see
Microphone on page 27)
(4) Rear-facing webcamera cable (see
Rear-facing webcamera on page 29)
(5) Front-facing webcamera cable (see
Front-facing webcamera on page 31)
(6) Power button board ZIF cable and connector, and detach the power button board cable (7)
from the display panel assembly. (The power button board cable is attached to the display panel
assembly with double-sided adhesive; see
Power button board on page 32)
(8) Volume button board ZIF cable and connector, and detach the volume button board cable (9)
from the display panel assembly. (The volume button board cable is attached to the display panel
assembly with double-sided adhesive; see
Volume button board on page 35)
(10) GPS antenna cable, and release the GPS antenna cable (11) from the retention clip built
into the display panel assembly (see
GPS antenna on page 25)
3.
Remove the two Phillips PM1.5×2.5 screws (1) that secure the system board to the display panel
assembly.
4. Detach the metal shielding (2) that secures the system board to the display panel assembly. (The
metal shielding is attached to the display panel assembly with double-sided adhesive.)
40 Chapter 5 Removal and replacement procedures