HP StorageWorks ExDS9100c SAS controller battery customer self repair instructions (448024-002, November 2008)

Verifying component status
Verify that the battery is working properly:
• Check the controller and battery LEDs. See Table 1.
• Open your management software utility and view the status of each
controller and its batteries.
• BecausethisdeviceispartoftheExDS9100solution,seethe
ExDS9100 administration guide for additional information.
IMPORTANT:
If the battery has a low charge when installed, the system
temporarily disables the battery while automatically recharging
the battery. When the battery charge is full, the system
automatically enables the battery for use. This process might take
up to four hours. During this time, the cache module functions
properly, but without the performance advantage of the battery
pack. No user action is required.
Disposing of an old battery
WARNING!
The controller uses Nickel Metal Hydride (NiMH) batteries. There
is risk of explosion, fi re, and personal injury if the battery pack is
incorrectly replaced or mistreated. To reduce the risk of personal
injury:
• Do not attempt to recharge the battery.
• Do not expose to temperatures higher than 60
o
C
• Do not disassemble, crush, puncture, short external contacts,
or dispose of in fire or water.
• Replace only with HP spare designated for this product.
For more information about battery replacement or proper
disposal, contact your HP Authorized Reseller or your Authorized
Service Provider.
CAUTION:
Do not dispose of batteries, battery packs, and accumulators
with general household waste. Use the public battery collection
system or return them to HP, your authorized HP Partners, or their
agents. For more information about proper disposal, contact an
HP Authorized Reseller or Service Provider.
Ret
urning the failed component
Follow instructions shipped with the replacement part.
Additional information
HP: http://www.hp.com
HP support: http://www.hp.com/support
Page 3