HP StorageWorks ExDS9100c SAS controller battery customer self repair instructions (448024-002, November 2008)

Verifying component failure
IMPORTANT:
BecausethisdeviceispartoftheExDS9100solution,seethe
ExDS9100 administration guide for additional information.
Check the controller and battery LEDs.
Table 1 Bat
tery LED status
Item
Description Status
1BatteryLED
Green solid—Healthy condition; battery fully
charged
Green rap
id flash—Being recognized by
controller; flashes rapidly when battery first
installed and until recognized by controller
Green slo
w flash—Discharging, cache module
being po
wered by battery; action required
Amber flashing—Fault condition
2
Controller
LED
Green—System activity
Blinking amber—Fault condition
Off—No system activity
nl
nl
nl
nl
nl
nl
nl
nl
nl
nl
Removing the failed component
Remove the failed battery by squeezing the release tabs (1) and pulling
the battery straight out (2).
IMPORTANT:
As you remove the battery from the controller, keep it level until it
is completely disengaged. If the battery is tilted, it is possible to
damage the battery or controller.
Installing the replacement component
Insert the
new battery, making sure that it seats properly by clicking and
locking in
to place.
IMPORTANT:
As you insert the battery in the controller, keep it level until it
is completely installed. If the battery is tilted, it is possible to
damage the battery or controller.
nl
nl
Page 2