HP StorageWorks ExDS9100c SAS controller battery customer self repair instructions (448024-002, November 2008)

ManualsBrandsHP ManualsStorageExtreme Data Storage

HP StorageWorks

ExDS9100c SAS co

ntroller

battery customer self repair

instructions

Second edition: September 2008

The information in this document is subject to change without

notice.

Printed in Singapore.

www.hp.com

48024-002*

Customer self repair (CSR)

The following information is included in all CSR documents:

• Before you begin—Component-speciﬁc precautions or notices. Be

sure to read and observe these statements.

• Verifying component failure—Before replacing a component, confer

with HP technical support to verify that the hardware component

has failed and that you are authorized to replace it. Veriﬁcation

procedures may include:

• Viewing LED illumination patterns on the enclosure and the

component.

• Viewing system event logs or other reports generated by systems

management tools.

• Removing the failed component—Procedural steps to properly

remove the component, including illustrations.

• Installing the replacement component—Procedural steps to properly

install the component, including illustrations.

• Verifying component status — After replacing the component, verify

that the replacement component is operating properly. Veriﬁcation

procedures may include:

• Viewing LED illumination patterns on the enclosure and the

component.

• Viewing system event logs or other reports generated by systems

management tools.

Before

you begin

CAUTION:

When handling system components, there is a danger to

equipment from electrostatic discharge (ESD). Use proper

anti-static protection at all times:

• Keep the replacement component in the ESD bag until needed.

• Wear an ESD wrist strap grounded to an unpainted surface

of the chassis.

• If an ESD wrist strap is unavailable, touch an unpainted surface

of the chassis before handling the component.

• Never touch connector pins.

CAUTION:

eck the expiration date of the battery spare part kit, located

the label. If the battery in the spare part kit is discharged,

the system may not recharge it. Contact HP support before

proceeding.

Page 1

Summary of content (3 pages)

PAGE 1
HP StorageWorks ExDS9100c SAS controller battery customer self repair instructions Customer self repair (CSR) The following information is included in all CSR documents: • Before you begin—Component-specific precautions or notices. Be sure to read and observe these statements. • Verifying component failure—Before replacing a component, confer with HP technical support to verify that the hardware component has failed and that you are authorized to replace it.
PAGE 2
Verifying component failure Removing the failed component Remove the failed battery by squeezing the release tabs (1) and pulling the battery straight out (2). IMPORTANT: Because this device is part of the ExDS9100 solution, see the ExDS9100 administration guide for additional information. IMPORTANT: As you remove the battery from the controller, keep it level until it is completely disengaged. If the battery is tilted, it is possible to damage the battery or controller.
PAGE 3
Verifying component status Verify that the battery is working properly: • Check the controller and battery LEDs. See Table 1. • Open your management software utility and view the status of each controller and its batteries. • Because this device is part of the ExDS9100 solution, see the ExDS9100 administration guide for additional information. IMPORTANT: If the battery has a low charge when installed, the system temporarily disables the battery while automatically recharging the battery.