HP StorageWorks 600 Modular Disk System Maintenance and Service Guide (495106-001, September 2008)

Component identification 49
Item Description Status
1 Hard drive LEDs
Drive locate mode
(UID LED is flashing)
Green = The drive has been selected
by a management application and it is
operating normally.
Flashing amber (1 Hz) = The drive is
not selected and is indicating a
predictive failure.
Flashing amber/green = The drive has
been selected by a management
application and is indicating a
predictive failure.
Amber = The drive might or might not
be selected and is indicating drive
failure, link failure, or mismatched
configuration.
Off = The drive is not selected.
2 UID button/LED Blue = UID LED is enabled from the UID
button
Blue flashing = Item 1 is in locate mode
Off = UID LED is disabled
3 Internal Health LED Green = System health is good
Off = System is off
4 GSI LED Amber = Enclosure requires service
check: I/O, fan and power supply
LEDs, and AC power cables to power
supplies.
Off = Enclosure is functioning normally.
Rear panel components