HP StorageWorks 600 Modular Disk System Maintenance and Service Guide (495106-001, September 2008)

Removal and replacement procedures 42
11.
Lift up on the tab to release the latch, and then slide the cable management arm off to remove it.
12. Lay the drawer on its side with the hard drive bays facing down.
13. Remove the backplane cover plate.
Item Description
1 Flushmount T-10 Torx screws
2 T-15 Torx screws
3 5/8-in T-15 Torx screws
14. Remove the backplane board:
a. Remove the thumbscrews securing the backplane board to the drawer.
b. Disconnect the LED panel cable.