HP StorageWorks 600 Modular Disk System Maintenance and Service Guide (495106-001, September 2008)

Removal and replacement procedures 35
5.
Release the cable management arm and expand to the rear of the chassis.
6. Push the drawer in another 25 cm (10 in).
7. Install the power block ("Power block" on page 35).
WARNING: Pinch hazard—Keep hands out of front and rear of chassis when closing hard
drive drawers.
8. Install the hard drives.
9. Close the drawer.
10. Install all rear panel components.
11. Connect the cables.
Power block
To remove the component:
1. Power down the MDS600 ("Power down" on page 24).
2. Disconnect all cables.
3. Remove all power supplies ("Power supply" on page 30).
4. Remove the fans ("Fan" on page 29).
5. Remove the I/O modules ("Hot-plug I/O module" on page 30).
6. Disengage the cable management arm lock from each hard drive drawer:
a. Pull the mechanism up, and then toward the rear of the chassis to disengage it from the locking
plate.