HP StorageWorks 600 Modular Disk System Maintenance and Service Guide (495106-001, September 2008)

Removal and replacement procedures 31
3.
Remove the component as indicated.
To replace the component, reverse the removal procedure.
Hard drive drawer
To remove the component:
1. Power down the MDS600 ("Power down" on page 24).
2. Disconnect all cables.
3. Remove all power supplies ("Power supply" on page 30).
4. Remove the fans ("Fan" on page 29).
5. Remove all hard drives ("Hard drive" on page 26).
6. Be sure the hard drive drawer is closed all the way.
7. Remove the I/O modules ("Hot-plug I/O module" on page 30).
8. Pull down the handle on the front of the drawer but do not extend the drawer.