HP StorageWorks Interface Manager and Command View TL Installation Guide (March 2005)
Table Of Contents
- Title
- Contents
- About this Guide
- 1: Introduction
- 2: Hardware Installation
- Preparing the Installation
- Installing the Expansion Cage in the ESL Series Library
- Installing the Fibre Channel Interface Controllers into the Expansion Cage
- Installing the Interface Manager Card into the Expansion Cage
- Connecting the Cables
- Connecting the Interface Manager Card to the Fibre Channel Interface Controllers
- Connecting the SCSI Bus Cables
- Connecting the Fibre Channel Cables
- Connecting the Interface Manager Card to the LAN
- Connecting the PC or Laptop
- Completing the Hardware Installation
- 3: Configuration and Software Installation
- 4: Troubleshooting
- A: Serial and Ethernet Pin Assignments
- B: Regulatory Compliance Notice
- Federal Communications Commissions Notice
- Harmonics Conformance (Japan)
- German Noise Declaration
- C: Electrostatic Discharge
- D: Specifications
- Index
Configuration and Software Installation
61Interface Manager and Command View TL Installation Guide
OK and follow the instructions on the screen. If you are using a non-Windows
OS, you will be instructed how to download the JRE plugin. If the JRE plugin is
not available, then Command View TL will not run.
After the JRE is successfully installed, the Command View TL Launcher screen
is displayed.
Configuring Command View TL
After installing the Interface Manager card and Command View TL, you must
perform the following configuration steps using Command View TL:
■ Set the Command View TL administrative password.
■ Verify proxy settings for the management station.
■ Add all libraries to Command View TL that will be monitored.
■ Add the license key for Command View TL and any additional features that
you have purchased.
■ Configure properties for each library.
■ Configure host access (Secure Manager).
For complete instructions for each of these configuration steps, see “Initial
Configuration Steps” in Chapter 2 of the HP StorageWorks Interface Manager
and Command View TL User Guide.