HP StorageWorks ESL9000 Series Pass-Through Mechanism (PTM) Installation Guide (February 2005)

Installing a PTM

56 HP StorageWorks ESL9000 Series Pass-Through Mechanism (PTM) Installation Guide

Reinstalling the tape cartridge bins (ESL9326 only)

Once the PTM assembly is installed and centered, tighten the 10-32 screws to 30

+/- 3 in/lb. If necessary, reinstall the tape cartridge bins that were previously

removed. For PTM assemblies installed on either the left or right side of an

ESL9326 library, see Figure 19 on page 47.

Note: Do not reinstall tape cartridge bins for PTM assemblies that were installed on

ESL9595 libraries.

1. Position an empty bin label on the back wall of the library and secure it with

snap rivets.

2. Align the six molded mounting clips on the back of the tape cartridge bin with

the grouping of six vertically paired holes on the back wall of the library (see

Figure 28).

Figure 28: Reinstalling the bin shelf modules

1 ESL9326 tape cartridge bin 2 Nylon snap rivet (1 per module)