User's Manual

Digital Proofing: Step by step
23
5. Slide the meter along the ruler at a constant pace (still holding the button pressed).
6. Release the button.
7. Wait until all measurements have been transferred.
8. Repeat this action until all strips have been measured and click 'OK' to finish the measurement.
Note: Only when there is a measurement error (e.g. bad reading),
you will have to click the measurement button again (to restart
the session).
Gretag Eye One (manual mode)
1. Take the first chart and place the meter holder on the first patch (100%C 100%M 100%Y).
2. Click the manual measurement button.
3. Repeat this action until all patches have been measured and click 'OK' to finish the measurement.
Gretag SpectroScan
You are prompted to put the overprints chart on the measuring table.
1. Place the (first) overprints chart on the measuring table.
2. Click 'OK'. Paper hold will now be activated.
3. Align the crosshair of the meter on the top left crosshair on the paper and press 'OK' to continue.
4. Align the crosshair of the meter on the top right crosshair on the paper and press 'OK' to continue.
5. Align the crosshair of the meter on the bottom left crosshair on the paper and press 'OK' to
continue. The SpectroScan will now measure the (first) chart.
If you are measuring a chart that contains more than one page, you will be asked to put the next
page on the measuring table. Click 'OK' when the next chart is placed on the table and repeat the
alignment procedure to measure the next page. Repeat this procedure for every page (e.g.
sp16x16_1234 has 4 pages, spscan_nonuni_cmyk has 2 pages).
6. When all pages are measured, click 'OK' to finish the measurement.
Xrite DTP41
1. Have the first chart ready.
2. Click the manual measurement button. With every click one row will be measured.
3. Feed the first row through the DTP41. The row number is printed on the chart.