User guide

Configure fax dialing settings
1. From the Home screen on the product control panel, scroll to and touch the Administration button.
2. Open the following menus:
●
Fax Settings
●
Fax Send Settings
●
Fax Send Setup
●
Fax Dialing Settings
Configure any of the following settings:
Menu item Description
Fax Dial Volume Use the Fax Dial Volume setting to control the product's dialing volume level when
sending faxes.
Dialing Mode The Dialing Mode setting sets the type of dialing that is used: either tone (touch-tone
phones) or pulse (rotary-dial phones).
Fax Send Speed The Fax Send Speed setting sets the modem bit rate (measured in bits per second)
of the Analog Fax modem while sending a fax.
●
Fast (default) — v.34/max 33,600 bps
●
Medium — v.17/max 14,400 bps
●
Slow — v.29/max 9,600 bps
Redial Interval The Redial Interval setting selects the number of minutes between retries if the
number dialed is busy or not answering, or if an error occurs.
NOTE: You might observe a redial message on the control panel when both the
Redial On Busy and Redial On No Answer settings are set to off. This occurs when
the fax accessory dials a number, establishes a connection, and then loses the
connection. As a result of this error condition, the fax accessory performs three
automatic redial attempts regardless of the redial settings. During this redial
operation, a message displays on the control panel to indicate that a redial is in
progress.
Redial on error The Redial on error feature sets the number of times a fax number will be redialed
when an error occurs during a fax transmission.
Redial On Busy The Redial On Busy setting selects the number of times (0 through 9) the fax
accessory redials a number when the number is busy. The interval between retries is
set by the Redial Interval setting.
Redial On No Answer The Redial On No Answer setting selects the number of times the fax accessory
redials if the number dialed does not answer. The number of retries is either 0 to 1
(used in the U.S.) or 0 to 2, depending on the country/region setting. The interval
between retries is set by the redial interval setting.
ENWW
Configure fax dialing settings
175