HP StorageWorks Secure Key Manager Installation and replacement guide (AJ087-96013, November 2008)

3. Select the Configuration tab.
4. Select Key Management to open the Properties window.
5. Select Actions,thenLaunch Key Management Setup Wizard to launch the configuration wizard.
The configuration wizard establishes communication between the library and the SKM by setting
up the CAs and certificates on the library, entering the username and password, and entering the
IP addresses of the SKM. The wizard will verify the connectivity to the SKM when all the data has
been provided.
After completing these steps, the encryption policies you have chosen will be applied and maintained to
the LTO4 tape drives in those libraries and partitions.
For LTO4 tape drives in libraries or partitions with a KT (key per tape) or a KP (key per partition) policy,
all backups will be encrypted. Those tape drives will be able to read encrypted or unencrypted data.
Only LTO4 media may be written, but LTO2 and LTO3 data may be read.
For LTO4 tape drives in libraries or partitions with an NE (no encryption) policy, all backups will be
written unencrypted. These tape drives will read and write LTO3 and LTO4 media, and will read LTO2
media. Only unencrypted data may be read in tape drives with an NE policy.
32
Configuring the system