Maintenance and Service Guide

Docking connector cable

NOTE: The docking connector cable is included in the Cables/Connectors Kit, spare part number

744045-001.

Before removing the docking connector cable, follow these steps:

1. Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on,

and then shut it down through the operating system.

2. Disconnect the power from the tablet by unplugging the power cord from the tablet or the

Security Jacket.

3. Disconnect all external devices from the Security Jacket.

4. Remove the card reader cover and top cap (see

Card reader cover and Top cap on page 82).

5. If installed, remove the tablet from the Security Jacket (see

Card reader cover and Top cap

on page 82).

6. Remove the front cover (see

Front cover on page 84).

7. Remove the system board (see

System board on page 86).

Remove the docking connector cable:

1. Turn the system board upside down with the top toward you.

2. Remove the two Phillips PM1.9×3.4 screws (1) that secure the docking connector cable to the

system board.

3. Remove the docking connector bracket (2).

Security Jacket component replacement procedures