Maintenance and Service Guide

9. Remove the front cover by sliding it away from the Retail Jacket.

Reverse this procedure to install the front cover.

Bar code scanner module and Cable connector board

NOTE: The bar code scanner module and cable connector board spare part kits do not include the

respective cables. The cables are included in the Cable Kit, spare part number 744031-001.

Description Spare part number

Bar code scanner module 744037-001

Cable connector board 744034-001

Before removing the bar code scanner module and cable connector board, follow these steps:

1. Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on,

and then shut it down through the operating system.

2. Disconnect the power from the tablet by unplugging the power cord from the tablet or the

Retail Jacket.

3. Disconnect all external devices from the Retail Jacket.

4. Remove the top cap (see

Top cap on page 67).

5. If installed, remove the tablet from the Retail Jacket (see

Top cap on page 67).

6. Remove the front cover (see

Front cover on page 69).

Remove the bar code scanner module and cable connector board:

1. Turn the front cover upside down with the top toward you.

2. Release the ZIF connector (1) to which the cable connector board cable is attached, and then

disconnect the cable connector board cable from the system board.

Retail Jacket component replacement procedures