Maintenance and Service Guide

5. Remove the NFC antenna (see NFC antenna on page 38).
6. Remove the power button board (see
Power button board on page 45).
Remove the battery:
1. Release the volume button board cable from the retention clips (1) built into the battery.
2. Release the tab (2) built into the bottom cover that secures the WWAN/GPS antenna cables, and
then release the antenna cables (3).
3. Detach the WWAN/GPS main transceiver (4) from the bottom cover. (The WWAN/GPS main
transceiver is attached to the bottom cover with double-sided adhesive.)
4. Remove the six Phillips PM1.3×2.0 screws (5) that secure the battery to the bottom cover.
5. Remove the battery (6).
Reverse this procedure to install the battery.
52 Chapter 5 Removal and replacement procedures