Service and Maintain

Any one of the following may be installed in the computer:
One 3.5-inch hard disc drive
One 2.5-inch solid state drive (SSD) or self-encrypting drive (SED)
Two 2.5-inch solid state drives or self-encrypting drives
NOTE: Replacing a 3.5-inch drive with a 2.5-inch drive is not supported.
Removing a hard disc drive
Installing a hard disc drive
Removing a hard disc drive
Removing a 3.5-inch hard disc drive
Removing a 2.5-inch hard disc drive
Removing a 3.5-inch hard disc drive
1. Prepare the computer for disassembly (see Preparing to disassemble the computer on page 35).
2. Remove the access panel (see
Access panel on page 39).
3. Pull the latch next to the lower side of the drive cage away from the cage to release it, then slide
the cage toward the edge of the chassis and lift it out.
48 Chapter 5 Removal and Replacement Procedures All-in One (AIO) Chassis