Specifications

Fingerprint reader board
Description Spare part number
Fingerprint reader board (includes cable) 486309-001
Before removing the fingerprint reader board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC Adapter from the computer.
4. Remove the battery (see
Battery on page 43).
5. Remove the following:
a. Hard drive (see
Hard drive on page 49)
b. Keyboard (see
Keyboard on page 57)
c. Switch cover (see
Switch cover on page 66)
d. Display assembly (see
Display assembly on page 77)
e. Top cover (see
Top cover on page 82)
f. Audio/ExpressCard assembly (see
Audio/ExpressCard assembly on page 89)
Remove the fingerprint reader board:
1. Remove the fingerprint reader board cable (1) from the opening in the top cover.
2. Remove the fingerprint reader board (2) by lifting it straight up. The fingerprint reader board is
attached to the top cover using double-sided tape.
Reverse this procedure to install the fingerprint reader board.
86 Chapter 4 Removal and replacement procedures