HP SlateBook 10 x2 PC Maintenance and Service Guide

4.
Detach the wireless antenna transceivers (4) from the surfaces of the battery and the display panel
frame. (The wireless antenna transceiver is attached to the surfaces of the battery and the display
panel frame with double-sided tape.)
5. Remove the wireless antenna.
Reverse this procedure to install the wireless antenna.
Power button board
Description Spare part number
Power button board (includes cable) 728150-001
Before removing the power button board, follow these steps:
1. Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on,
and then shut it down through the operating system.
2. Disconnect the power from the tablet by unplugging the power cord from the tablet.
3. Disconnect all external devices from the tablet.
4. Remove the display enclosure (see
Display enclosure on page 20).
5. Disconnect the battery cable from the system board (see
Rear webcam on page 21).
26 Chapter 4 Removal and replacement procedures preliminary requirements