HP SlateBook 10 x2 PC Maintenance and Service Guide

Remove the display panel cable (3).

Reverse this procedure to install the display panel cable.

Wireless antenna

Description Spare part number

Antenna Kit (includes wireless antenna cable and transceiver) 728134-001

Before removing the wireless antenna, follow these steps:

1. Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on,

and then shut it down through the operating system.

2. Disconnect the power from the tablet by unplugging the power cord from the tablet.

Disconnect all external devices from the tablet.

4. Remove the display enclosure (see

Display enclosure on page 20).

5. Disconnect the battery cable from the system board (see

Rear webcam on page 21).

Remove the wireless antenna:

1. Disconnect the wireless antenna cable (1) from the terminal on the WLAN module.

2. Detach the piece of tape (2) that secures the wireless antenna cable to the battery.

3. Release the wireless antenna cable from the routing clips (3) built into the display panel frame.

Removal and replacement procedures