HP SlateBook 10 x2 PC Maintenance and Service Guide

Removal and replacement procedures
Tablet component replacement procedures
CAUTION: Tablet components described in this chapter should only be accessed by an authorized
service provider. Accessing these parts can damage the tablet and void the warranty.
This chapter provides removal and replacement procedures for authorized service provider only parts.
There are as many as 16 screws that must be removed, replaced, and/or loosened when servicing the
tablet. Make special note of each screw size and location during removal and replacement.
Display enclosure
Description Spare part number
In royal blue finish 728137-001
In smoke silver finish 728135-001
In snow white finish 728136-001
Before disassembling the tablet, follow these steps:
1. Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on,
and then shut it down through the operating system.
2. Disconnect the power from the tablet by unplugging the power cord from the tablet.
3. Disconnect all external devices from the tablet.
Remove the display enclosure:
CAUTION: Before positioning the tablet with the display screen facing down, make sure the work
surface is clear of tools, screws, and any other foreign objects. Failure to follow this caution can result
in damage to the display screen.
1. Lift up on the bottom edge of the display enclosure (1) until the tabs built into the enclosure release
from the display assembly.
20 Chapter 4 Removal and replacement procedures preliminary requirements