HP LaserJet Enterprise M604, M605, M606 - Warranty and Legal Guide
Additional statements for wireless products
FCC compliance statement—United States
Exposure to radio frequency radiation
CAUTION: The radiated output power of this device is far below the FCC radio frequency exposure limits. 
Nevertheless, the device shall be used in such a manner that the potential for human contact during normal 
operation is minimized.
In order to avoid the possibility of exceeding the FCC radio frequency exposure limits, human proximity to the 
antenna shall not be less than 20 cm (8 in) during normal operation.
This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions: (1) this 
device may not cause interference, and (2) this device must accept any interference, including interference 
that may cause undesired operation of the device.
CAUTION: Based on Section 15.21 of the FCC rules, changes of modications to the operation of this product 
without the express approval by HP may invalidate its authorized use.
Australia statement
This device incorporates a radio-transmitting (wireless) device. For protection against radio transmission 
exposure, it is recommended that this device be operated no less than 20 cm from the head, neck, or body.
Brazil ANATEL statement
Este equipamento opera em caráter secundário, isto é, não tem direito à proteção contra interferência 
prejudicial, mesmo de estações do mesmo tipo, e não pode causar interferência a sistemas operando em 
caráter primário.
Canadian statements
For Indoor Use. This digital apparatus does not exceed the Class A limits for radio noise emissions from 
digital apparatus as set out in the radio interference regulations of the Canadian Department of 
Communications. The internal wireless radio complies with RSS 210 of Industry Canada.
Pour l´usage d´intérieur. Le présent appareil numérique n´émet pas de bruits radioélectriques dépassant les 
limites applicables aux appareils numériques de Classe A prescribes dans le règlement sur le brouillage 
radioélectrique édicté par le Ministère des Communications du Canada. Le composant RF interne est conforme 
à la norme CNR-210 d´Industrie Canada.
Exposure to Radio Frequency Radiation (Canada)
WARNING! Exposure to Radio Frequency Radiation. The radiated output power of this device is below the 
Industry Canada radio frequency exposure limits. Nevertheless, the device should be used in such a manner 
that the potential for human contact is minimized during normal operation.
To avoid the possibility of exceeding the Industry Canada radio frequency exposure limits, human proximity 
to the antennas should not be less than 20 cm (8 inches).
40 Chapter 3 Regulatory information ENWW










