HP LaserJet Enterprise M604, M605, M606 - User Guide
●
Administration
●
Network Settings
●
Jetdirect Menu
●
TCP/IP
●
IPV6 Settings
●
Address
●
Manual Settings
●
Enable
Select the On option, and then touch the Save button.
3. To congure the address, touch the Address button and then touch the eld to open a keypad.
4. Use the keypad to enter the address, and then touch the OK button.
5. Touch the Save button, or press the OK button.
Link speed and duplex settings
NOTE: This information applies only to Ethernet networks. It does not apply to wireless networks.
The link speed and communication mode of the print server must match the network hub. For most situations,
leave the product in automatic mode. Incorrect changes to the link speed and duplex settings might prevent the
product from communicating with other network devices. To make changes, use the product control panel.
NOTE: The product setting must match the setting for the network device (a network hub, switch, gateway,
router, or computer).
NOTE: Making changes to these settings causes the product to turn o and then on. Make changes only when
the product is idle.
1. Press the Home button on the product control panel.
2. Open the following menus:
●
Administration
●
Network Settings
●
Jetdirect Menu
●
Link Speed
3. Select one of the following options:
●
Auto: The print server automatically congures itself for the highest link speed and communication
mode allowed on the network.
●
10T Half: 10 megabytes per second (Mbps), half-duplex operation
●
10T Full: 10 Mbps, full-duplex operation
●
10T Auto: 10 Mbps, automatic-duplex operation
76 Chapter 5 Manage the product ENWW