Administrator's Guide

4. Confirm the firmware version.
NOTE: You must reboot the storage solution after updating Mezzanine NIC and server blade
firmware.
Removing and replacing the PCIe module (with card)
IMPORTANT: Be sure to unpack the replacement part before you remove the existing component.
This section describes how to remove and replace the PCIe module (with card) in the messaging
system.
Removing the PCIe module
To remove the PCIe module:
1. Use System Manager to identify the failed component.
2. Verify the failed component by checking for a blinking amber LED on the failed component.
3. Power off the appropriate server blade associated with the PCIe module that is being removed.
CAUTION: Be sure to power off the server before removing the PCIe module.
4. Label the cables so they can be returned to their original locations.
5. Unplug all cables from the PCIe module.
6. Press the PCIe module release mechanism to release the handle (1), and then pull the handle
to remove the PCIe module from the system (2).
Removing and replacing the PCIe module (with card) 95