Administrator's Guide

Removing the HP StorageWorks Ethernet I/O module
To remove the HP StorgeWorks Ethernet I/O module in the network or Mezz slots of the system
enclosure:
1. Use System Manager to identify the failed component.
2. Verify the failed component by checking for a blinking amber LED on the failed component.
3. Label the cables, and then unplug all cables from the HP StorageWorks Ethernet I/O module.
4. Press the module release mechanism to the right (1), and then remove the failed module (2).
Replacing the HP StorageWorks Ethernet I/O module
To replace the HP StorgeWorks Ethernet I/O module in the network or Mezz slots of the system
enclosure:
1. Insert the replacement HP StorageWorks Ethernet I/O module.
2. Plug in all cables to the replacement module to their original locations.
3. Verify that the replacement component is working properly by checking the associated LED
status.
4. Confirm the firmware version.
Removing and replacing the HP StorageWorks Ethernet I/O module 91