Administrator's Guide

http://www.hp.com/go/ilo. On the iLO web page, select iLO Firmware (under iLO Support &
Downloads, on the right), then select Manuals (from menu on the left).
If you are using the direct connect method, connect the supplied SUV cable to the front of the
messaging system server blades in the following sequence: keyboard, mouse, monitor cable, and
monitor power cable.
NOTE: The keyboard, mouse, and monitor are not provided with the messaging system.
Figure 9 Keyboard, mouse, and monitor
1. Messaging system enclosure
2. Monitor
3. Keyboard
4. Mouse
Adding expansion nodes to an installed messaging system
To add expansion nodes to the messaging system:
1. Use the Exchange Management Console or the Exchange Management Shell to failover the
databases from the bay 1 server to the bay 2 server.
2. Power on the expansion node.
3. Reboot the bay 1 server and run the E5000 Configuration Wizard on the bay 1 server from
the All Programs shortcut.
CAUTION: In some cases, when adding new expansion nodes, disks are seen through a
single path. This condition is reported as an error in the diagnostics initially performed by HP
E5000 Configuration Wizard. To fix this problem, power cycle the expansion nodes by
pressing and holding the button on the back of the unit, then pressing and holding the button
once again to power them back on. Then re-run the HP E5000 Configuration Wizard from
the All Programs shortcut.
For instructions, see (page 24).
The messaging system identifies the new storage and creates new LUNs.
4. Exit the Initial Configuration Wizard at the first opportunity.
5. On the bay 2 server, use the Exchange Management Console or the Exchange Management
Shell to manually failover the databases from the bay 2 server to the bay 1 server.
6. Reboot the bay 2 server and manually run the E5000 Configuration Wizard on the bay 2
server.
22 Installing the messaging system