Administrator's Guide

3. Press and hold down the UP button for 3 seconds.
The EM flashes the display “dH” to indicate acceptance of the command.
4. Release the UP button.
The system sets the EM to DHCP and exits the menu mode. This event is also logged in the
EM syslog and takes effect immediately. The system displays the Enclosure ID to indicate that
the operation is complete.
Set Link Local IP Address (LL)
You need to reconfigure the messaging system for a network where IP address assignment is static.
Procedure:
1. Enter the menu mode by performing Activate Button Menu.
2. Press the UP button six times so that the display changes from “_ _“ to “LL” (Set Link Local
Mode).
3. Press and hold down the UP button for 3 seconds.
The EM flashes the display “LL” acknowledging the operator’s request.
4. Release the UP button.
The system then sets the EM to Link Local mode and exits menu mode. The system also logs
this event in the EM syslog and the effect on network configuration is immediate. The system
displays the Enclosure ID to indicate that the operation is complete.
Display Current IP Address (IP)
You need to learn the IP address of the EM.
Procedure:
1. Enter the menu mode by performing Activate Button Menu.
2. Press the UP button six times so that the display changes from “_ _“ to “IP” (Display IP Address).
3. Press and hold the down UP button for 3 seconds.
The EM displays “IP” acknowledging the request.
4. Release the UP button.
System then enters the ‘Display IP’ sub function and displays the first octet of the IPv4 address
being used by the EM.
5. You may press the UP button 3 more times to scroll through the other 3 octets of the EM IP
address. You can backup using the DOWN button.
6. Press and hold the DOWN button for 3 seconds.
The EM flashes displays “IP” acknowledging the operator’s request and then exits the operation.
The system displays the Enclosure ID to indicate that the operation is complete.
Exit Button Menu
You want to exit the main menu (or any sub function).
Procedure: Press and hold the DOWN button for 3 seconds.
The system displays and flashes the two hyphens (“- -“) three times to indicate the menu was exited.
The system then returns the LEDs to their original display state showing the enclosure ID.
Manual button functions 187