Administrator's Guide

NOTE: Once the pause has begun, there is no way to continue the session before time runs out,
but you can always terminate the session (form the client end) and start another one.
Restrictions
<seconds> parameter can be any whole number from 1 to 86400.
HISTORY
Syntax
HISTORY
Description
Shows the history of commands for the current session.
Restrictions
None
Manual button functions
The primary interface to the Enclosure Manager is its Ethernet LAN port, which is intended for
remote management of the enclosure. AC power is applied to the enclosure so that aux power is
available to the EM. The enclosure may or may not be powered on. Solution software may or may
not be installed.
IMPORTANT: Use the following manual button functions only with the assistance of HP Technical
Support.
The two manual buttons and two-digit LED display on the EMU provide basic management functions
when the EM is not connected to the network. The figure below illustrates the physical (touch/visual)
interaction elements:
Figure 24 EM Physical Interface
Activate Button Menu
You cannot manage the EM using a remote management interface because the system is not
connected to the LAN, the LAN interface is not functioning properly, or management software is
not installed or available.
Procedure:
1. Press and hold the UP (left) button until the two digits display “- -“.
2. Release the UP button. System displays two underscores “_ _”:
This display indicates context is at the bottom of the menu range and is awaiting menu selection,
which requires pressing UP button one or more times.
Manual button functions 185