Administrator's Guide

exchange between iLO and EM have not normalized, some displayed information may show
‘[Unknown]’ or ‘?’.
Example
EM-78E7DC12074> show server names
Bay Server Name Serial Number Status Power UID
--- ----------------------------- --------------- -------- ------- ---
1 MSATAZ2 MXQ9350526 OK On On
2 MSATAZ1 MXQ93305T8 OK On On
Totals: 2 server blades installed, 2 powered on.
SHOW SERVER BOOT
Syntax
SHOW SERVER BOOT { ALL | <bay#> [{ - | , } <bay#>
Description
Displays the boot order and one-time boot device for the specified server or range of servers. These
settings correspond to the server boot settings in the ROM-Based Setup Utility (RBSU).
Restrictions
This command functions only if the enclosure power is already on. Because the EM hardware
cannot determine if a blade is physically present unless enclosure power is on, the EM reports the
warning that the blade is not present if this command is used when enclosure power is off.
Example
This example is with enclosure power off:
This example is with enclosure power off:
EM-78E7DC12074> show server boot all
Server Blade #1 Boot Information:
The blade is not present.
Server Blade #2 Boot Information:
The blade is not present.
This example is same system with enclosure power on:
EM-78E7DC12074> show server boot all
Server Blade #1 Boot Information:
One time boot from: NoneIPL Devices (Boot Order):
CD-ROM
Diskette Drive (A:)
USB
Hard Drive (C:)
PXE NIC 1
Server Blade #2 Boot Information:
One time boot from: NoneIPL Devices (Boot Order):
CD-ROM
Diskette Drive (A:)
USB
Hard Drive
PXE NIC 1
SHOW SERVER INFO
Syntax
SHOW SERVER INFO { ALL | <bay#>[{ , | - } <bay#>]}
Description
Displays a description of the server blade hardware, including the embedded NICs, the Mezz
HBAs, and the management processor, in the specified bay or 2 bays.
174 EMU reference