Administrator's Guide

5. Press the release button on the access panel and slide the access panel to the left to remove
it.
6. Since the original P1210m cache module is connected to a capacitor pack, observe the cache
module LEDs.
• If the amber P1210m cache LED is solid, data transfer to the flash device on the cache
is in progress. Do not remove the P1210m cache until the amber LED is off, and then
continue with the next step.
• If the amber P1210m cache LED is not lit proceed to the next step.
7. Open the ejector latches on each side of the P1210m cache module slot.
Typically, opening the ejector latches ejects the cache module automatically. If the module
does not eject automatically after you open the ejector latches, remove the cache module (2)
by grasping only the edges.
142 Removing and replacing hardware components