Administrator's Guide

6. Press the release button on the access panel and slide the access panel to the left to remove
the access panel.
7. The original cache module is connected to a capacitor pack, so observe the cache module
LEDs.
• If the amber LED is solid, data transfer to the flash device on the cache module is in
progress. Do not remove the cache module until the amber LED is off, and then continue
with the next step.
• If the amber LED is not lit, proceed to the next step.
8. Open the ejector latches (1) on each side of the cache module slot.
Typically, opening the ejector latches ejects the cache module automatically. If the module
does not eject automatically after you open the ejector latches, remove the cache module (2)
by grasping only the edges.
9. Remove the cache module and the capacitor from the blade.
10. Loosen two captive screws and remove the controller card.
140 Removing and replacing hardware components