Administrator's Guide

2. Push the drive drawer back into the messaging system enclosure.
3. Verify that the replacement component is working properly by checking the associated LED
status.
NOTE: This may require a wait time of less than 15 seconds for the LED status to appear.
4. Confirm the messaging system has resumed normal operations.
5. Confirm the hard drive firmware version.
IMPORTANT: You must reboot the storage solution after updating the drive drawer hard
drive firmware.
Removing and replacing the drive drawer rails (side or bottom)
This section describes how to remove and replace the drive drawer rails in the messaging system.
NOTE: Spare rail kits consist of rail pairs, one enclosure bay rail, and one drive drawer rail.
See “Removing and replacing the enclosure rails” (page 132) for enclosure rail instructions.
Removing the drive drawer rails
To remove the drive drawer rails:
1. Power off the system:
1. Shut down blade 2 by clicking on Start and then Shut Down while you are connected to
blade 1.
2. Shut down blade 1 by clicking on Start and then Shut Down while you are connected to
blade 2.
3. Power off the expansion nodes, if present, by pressing and holding the power button at
the back.
4. Power off the storage solution by pressing and holding the power button at the back of
the enclosure.
5. Disconnect the power cables.
2. Extend the hard drive drawer:
1. Press upward on the release button on the hard drive drawer (1).
2. Pull the drawer handle down 90 degrees (2).
3. Extend the hard drive drawer (3).
3. Label the hard drives.
126 Removing and replacing hardware components