Administrator's Guide

1. Install the replacement LED display board (1), replace the four LED display board screws (2),
and then reconnect the LED display board to the drive drawer (3).
2. Replace the front bezel with the handle at a 90 degree angle making sure the bottom pins
are aligned with the bottom holes (1), and replace the front bezel screws (2).
NOTE: There are two screws on the bottom, four screws on the sides (two on each side),
and two screws hidden behind the handle.
3. Close the drawer handle.
4. Place the enclosure in the rack, and tighten the two retaining screws.
WARNING! The messaging system enclosure is heavy, even after removing the hard drives.
Always use at least two people to replace the messaging system in the rack.
5. Replace the server blades into their original bays.
6. Extend the hard drive drawer:
1. Press upward on the release button on the hard drive drawer (1).
2. Pull the drawer handle down 90 degrees (2).
Removing and replacing the front LED display board (full) 117