Administrator's Guide

4. Pull the hard drive drawer handle down 90 degrees, and slide out the hard drive drawer.
5. Remove all eight screws from front bezel (1, Figure 93 (page 98)). Then, lift the front bezel
up and out to remove the front bezel (2).
NOTE: There are two screws on the bottom, four screws on the sides (two on each side),
and two screws hidden behind the handle.
Figure 93 Removing the front bezel
6. Complete the following (Figure 94 (page 98)):
a. Disconnect the LED display board from the drive backplane by pinching the ends of the
LED display board cable together (1).
b. Remove the four screws from the LED display board (2).
c. Remove the LED display board from the drive drawer (3).
Figure 94 Removing the front LED display board
98 Removing and replacing hardware components