Administrator's Guide

Table 5 1210m Cache module controller LED status (continued)
StatusDescriptionItem
Green flashing (2 Hz) alternating with amber; amber flashing
(2 Hz) alternating with green LED = One of the following
condition exists:
– The charging process has timed out.
– The capacitor pack is not connected.
Green on, amber on = The flash code image failed to load.
Green off, amber off = The flash code is corrupt.
Figure 37 Enclosure Manager unit LEDs
Table 6 Enclosure manager unit LEDs status
StatusDescriptionItem
The LED blinks during power-up, but then the display changes only in
response to commands from the Enclosure Manager Display.
EM display1
Amber flashing/green LED off = issue. Use the CLI commands SHOW
ENCLOSURE STATUS and SHOW SYSLOG EM to determine possible
fault causes.
EM fault LED2
The health LED is only green and is either on (Healthy) or off (Power
off or Faulted).
EM health LED3
LEDs are off when the enclosure is powered off.
Figure 38 HP 2-port 1 GB Ethernet I/O modules LEDs
Component LEDs 51