Administrator's Guide

Once you make a selection or if you choose to skip the Jetstress test, click Next. The
Prerequisite Checks screen appears (Figure 18 (page 29)).
4. The Prerequisite Checks screen displays the status check results for the configuration settings
in your environment.
If a test fails, the Next button is disabled and you are not allowed to proceed. Check the logs
for the configuration setting failure details and correct the failed setting. Click Refresh checks
to verify the settings.
If all tests pass with either a green checkmark or warning, the Next button is enabled. Click
Next to start deployment of the Exchange Administration Tools.
Figure 18 Prerequisite Checks
5. After the installation of the Exchange Administration Tools finishes, complete the fields on the
Custom Input window.
When deploying to the Bay 1 server, select First blade. The E5000 Exchange Deployment
Tool automatically detects whether any servers are found in the existing Exchange organization
(when existing is selected). When deploying to the Bay 2 server, select Second blade. The
name of the second blade of Bay 1 server is autodetected.
Complete each item on this screen as needed for your deployment:
• New or existing Availability Group (DAG) name. The E5000 Exchange Deployment Tool
automatically detects if any DAGs are found in the existing Exchange organization.
Accept the default name or enter a new name of a DAG that already exists.
• Availability Group IP address. Using an IP address of 0.0.0.0 configures the DAG to use
DHCP. You can update the configured IP address later using the Exchange Management
Deploying Microsoft Exchange Server 2010 29