Administrator's Guide
IMPORTANT:
• By default, the Replication network is set to a static network (10.0.0.0/30) with IP
10.0.0.1 on the first node and 10.0.0.2 on the second node. A cable directly connects
the two ports. If these addresses conflict with addresses on your network, reconfigure
them to some other unused static network. If the replication ports will be connected to a
switch, you might have to change the network settings. You can either automatically
configure with DHCP or manually enter a specific IP address.
• Be careful not to put the Client/MAPI and Replication networks on the same subnet. If
you attempt to do so, the wizard displays a warning.
Figure 13 (page 24) shows an E5500/5700 configuration that has four networks per server:
Client/MAPI, Replication, Management, and Alternate. The E5300 configuration has two
(standard) networks per server: Client/MAPI and Replication.
Figure 13 Network configuration
4. Enter the EMU Administrator password and then click Next.
The default password is printed on a label attached to the underside on the EMU module. The
default password is also printed on a tear-away label attached to the rear of the enclosure
(Figure 11 (page 19)). Remove the tear-away label and store it in a safe place. After you
enter the password, an animated icon indicates that the wizard is verifying connection to the
enclosure.
24 Configuring the messaging system software