Administrator's Guide

ResolutionDescriptionPhase
Error
Code
Verify that C:\ExchangeDatabases\VOLx exists
(disks are online). You may need to replace physical
EDT Error: Expected VOL mismatch.
VOL$i not found.
2- Exchange
Tools install, 3-
Setup prep, 4-
Exchange Setup
1141
disks and then re-run the E5000 Configuration
Wizard and the Exchange Deployment Tool.
Check C:\ExchangeSetupLogs to determine
why Microsoft Exchange failed to install the
EDT Error: Exchange did NOT
install, check C:\
4- Exchange
Setup
1142
administrator tools. This is an Exchange Setup error,
not an Exchange Deployment Tool error.
ExchangeSetupLogs\Exc
hangeSetup.log for full details.
A dialog box should appear and prompt you to
re-enter the license key. You can also proceed with
EDT Error: Enterprise Edition license
required for this configuration (more
than 5 databases).
4- Exchange
Setup
1143
the setup and address the license key issue later.
For more information, see “set-ExchangeServer” on
TechNet.
Verify that C:\ExchangeDatabases\VOLx exists
(disks are online). You may need to replace physical
EDT Error: Expected VOL mismatch.
VOL$i not found.
5- Exchange
post-setup
(config)
1151
disks and then re-run the E5000 Configuration
Wizard and the Exchange Deployment Tool.
Check C:\ExchangeSetupLogs to determine
why Microsoft Exchange failed to install. The
EDT Error: Exchange is NOT
installed, check C:\
5- Exchange
post-setup
(config)
1152
Exchange Deployment Tool has stopped becauseExchangeSetupLogs\
it detects that the previous phases have not been
ExchangeSetup.log for full
details.
completed. View the error log using the button in
the Exchange Deployment Tool.
Check input and see http://go.microsoft.com/?
linkid=9751386 for more information. View the
EDT Error: Cannot join DAG -5- Exchange
post-setup
(config)
1154
error log using the button in the Exchange
Deployment Tool.
Check input (e.g., Witness Server) and see http://
go.microsoft.com/?linkid=9751386 for more
Error: Cannot create DAG -5- Exchange
post-setup
(config)
1155
information. View the error log using the button in
the Exchange Deployment Tool.
Check C:\ExchangeSetupLogs\DagTasks log
and see http://go.microsoft.com/?linkid=9751386
EDT Error: $localserver Did not
join $DAGname -
5- Exchange
post-setup
(config)
1156
for more information. View the error log using the
button in the Exchange Deployment Tool.
Check that the first server is correctly installed. This
occurs on the second server.
Error: Exchange Server
$server1name NOT valid. Verify
your inputs.
5- Exchange
post-setup
(config)
1157
Check C:\ExchangeSetupLogs to determine
why Microsoft Exchange failed to install. The
EDT Error: Exchange is NOT
installed, check C:\
6- EDT exit (to
ExBPA)
1162
Exchange Deployment Tool has stopped becauseExchangeSetupLogs\
it detects that the previous phases have not been
ExchangeSetup.log for full
details.
completed. View the error log using the button in
the Exchange Deployment Tool.
Firmware Update
ResolutionDescriptionError
Code
See the error message for details. The UpgradeSelected.xml
file must be deleted after a firmware upgrade has completed
(W) Error deleting file
UpgradeSelected.xml.
2048
for discovery to work correctly. The file is located in C:\
168 E5000 Error Codes