Administrator's Guide

Restrictions
• <ip address> and <netmask> must be in the form ###.###.###.###, where each ###
ranges from 0 to 255.
• <domain name> is a string containing letters (a–z, A–Z), digits (0–9), or a hyphen (-).
• <bay#> must be 1 or 2.
SET EM GATEWAY
Syntax
SET EM GATEWAY [<bay number>] <ip address>
Description
Sets the network default gateway. <bay number> is optional because there is only one EMU
bay.
Restrictions
• This gateway is used only if the system is currently configured to use a static IP address rather
than the DHCP protocol.
• <ip address> must be in the form ###.###.###.###, where each ### ranges from 0 to
255.
• 1 is the only valid value for <bay number> because there is no bay 2.
PING
Syntax
PING IPV6 [<NUMBER>] {<ipv6 address> | "<server name>"}
Description
Sends ICMP echo messages to a remote IPv6 device. If you omit <NUMBER>, or use a number
larger than 9999 or one that is negative, then only four packets are sent. Packets are sent at
one-second intervals to prevent congestion.
Restrictions
• <NUMBER> must be between 1 and 9999.
• IPv6 must be enabled.
• <ipv6 address> must be in the format ####:####:####::##.
SET IPCONFIG
Syntax
SET IPCONFIG { DHCP | STATIC | LOCAL }
Description
Configures EM addressing mode to be DHCP, static, or link local. The setting takes effect
immediately. If mode chosen is static, other parameters are required (see below).
Restrictions
None
148 Managing the EMU