Administrator's Guide

3. Remove the server blade hard drive (Figure 132 (page 118)):
a. Press the release button (1).
b. Pull the release lever (2).
c. Remove the hard drive (3).
CAUTION: To prevent improper cooling and thermal damage, replace the drive quickly. Do
not operate the server unless all bays are populated.
Figure 132 Removing the server blade hard drive
Replacing the server blade hard drive
1. Install the hard drive (Figure 133 (page 118)):
a. Insert the replacement hard drive with the lever in the open position (1).
b. Push the release lever into place (2).
Figure 133 Installing the hard drive
2. Verify that the server blade hard drive is working properly by checking the associated LED
status.
NOTE: This may require a wait time of less than 15 seconds for the LED status to appear.
3. Confirm that the system has resumed normal operations.
4. Confirm the firmware version.
NOTE: You must reboot the system after updating a server blade hard drive.
118 Removing and replacing hardware components