Administrator's Guide

Figure 118 Reattaching the plug bracket to the coil power plug
5. Push the drive drawer fully back into the system enclosure (1, Figure 119 (page 111)) and the
handle back into place (2).
Figure 119 Pushing the drive drawer into the system enclosure
6. Replace the top back panel.
7. Replace the enclosure as described in “Inserting the system enclosure into the rack” (page 76).
Removing and replacing the enclosure rails
Removing the enclosure rails
1. Power off the system as described in “Powering the system off and on” (page 67).
2. Remove the enclosure as described in “Removing the system enclosure from the rack” (page 75).
Removing and replacing the enclosure rails 111