Administrator's Guide

Replacing the drive drawer
1. Unlock the side enclosure rail and push it into the back enclosure (Figure 102 (page 102)).
2. Align the bottom replacement drive drawer rails with the bottom enclosure rails.
Figure 102 Unlocking the enclosure rails
3. Align the side rails and then push the replacement drive drawer partially back into the system
enclosure until approximately two inches of the drawer is still out of the enclosure (Figure 103
(page 102)).
CAUTION: Do not push the drive drawer completely into the enclosure. You must first connect
the power coil assembly to prevent damaging the power coil assembly.
Figure 103 Partially installing the drive drawer
4. Pull the cable slightly out of the coil power plug and connect it to the midplane board
(Figure 104 (page 103)).
102 Removing and replacing hardware components