Administrator's Guide

Figure 97 Removing the SAS I/O module
8. Extend the drive drawer (Figure 54 (page 75)):
a. Press upward on the release button on the hard drive drawer (1).
b. Pull the drawer handle down 90 degrees (2).
c. Extend the hard drive drawer (3).
Figure 98 Extending the hard drive drawer
NOTE: You must repeat Step 8 for the remaining SAS I/O module.
9. Remove the plug bracket (2, Figure 99 (page 101)) from the coil power plug by removing the
thumbscrew (1).
100 Removing and replacing hardware components