"Regulations, Safety, and Environmental Notes" User Guide
Canada modem statements（カナダ向け）
This equipment meets the applicable Industry Canada technical specications.
The Ringer Equivalence Number, REN, is an indication of the maximum number of devices allowed to be
connected to a telephone interface.The termination on an interface may consist of any combination of
devices, subject only to the requirement that the sum of the RENs of all devices does not exceed 5.The REN
for this terminal equipment is 1.0.
日本でのモデム規定に関する記載
コンピューターの裏側に日本の認定マークが貼付されていない場合は、以下の中から該当する認定マ
ークを参照してください。
V.92 56K Data/Fax モデムの認証マーク：
コンピューターの裏側に日本の認定マークが貼付されていない場合は、以下の中から該当する認定マ
ークを参照してください。
LSI Corporation PCI-SV92EX Soft モデムの認定マーク：
New Zealand modem statements（ニュージーランド向け）
The grant of a Telepermit for any item of terminal equipment indicates only that Telecom has accepted that
the item complies with minimum conditions for connection to its network.
It indicates no endorsement of the product by Telecom, nor does it provide any sort of warranty.Above all, it
provides no assurance that any item will work correctly in all respects with another item of Telepermitted
equipment of a dierent make or model, nor does it imply that any product is compatible with all of Telecom's
network services.
This equipment is not capable, under all operating conditions, of correct operation at the higher speeds for
which it is designed.Telecom will accept no responsibility should diiculties arise in such circumstances.
If this device is equipped with pulse dialing, note that there is no guarantee that Telecom lines will always
continue to support pulse dialing.
Use of pulse dialing, when this equipment is connected to the same line as other equipment, may give rise to
bell tinkle or noise and may also cause a false answer condition.Should such problems occur, the user should
not contact the Telecom Faults Service.
Some parameters required for compliance with Telecom's Telepermit requirements are dependent on the
equipment (PC) associated with this device.The associated equipment shall be setto operate within the
following limits for compliance with Telecom's Specications:
モデムに関するご注意
11