HP Z220 SFF, Z220 CMT, Z420, Z620, and Z820 Workstations Maintenance and Service Guide

Heading Option Description
●
SAS Option ROM
1
Download (Enable/Disable) (Not available on HP Z220.)
●
SCU Option ROM Download (Enable/EFI/Disable) (Not available on HP Z220.)
●
Multiprocessor (Activates a single core.)—(Enable or Disable)
●
Active Processor Cores—Selects a single core, or multiple cores per socket
●
Hyper-Threading—(Enable or Disable)
●
CECP Mode—(Enable or Disable)
●
Thunderbolt (Legacy, Unique ID, One time saved key, DP++ only)—In Legacy
mode, all devices are allowed to connect without user intervention. In the default
Unique ID mode, device connection is managed by the Thunderbolt service running
on the host system. One time saved key mode allows the Thunderbolt host
controller to differentiate between multiple devices of the same type connected to
Falcon Ridge devices. DP++ only mode allows monitor-only connections, so there is
no data traffic. Not available on HP Z220.
Slot Settings Enable/disable the PCIe and PCI slots (1 - 7).
AMT
Configuration
Lets you set the following AMT (Intel Active Management Technology) configuration
options:
●
AMT (Enabled/Disabled)—Allows for remote discovery, repair and protection of
networked workstations. Enabling the AMT function also enables the Network
Controller (required for AMT to function correctly).
●
Unconfigure AMT/ME (Disabled/Enabled) 2—Restores AMT/ME defaults. When you
save and exit after enabling this option, you will be prompted to complete the
process upon restart. A Setup Password (even if one is set) does not need to be
entered to complete the process.
NOTE: Information about Intel AMT can be found at
http://www.intel.com.
●
WatchDog Timer (Enabled/Disabled)—OS and BIOS WatchDog Timers can be set
independently (in minutes):
◦
OS WatchDog TimerTimer—Sets the OS WatchDog Timer
◦
BIOS WatchDog Timer—Sets the BIOS WatchDog Timer
1
Available on selected models
2
These options should be used by advanced users only
56 Chapter 2 System management