HP Z220 SFF, Z220 CMT, Z420, Z620, and Z820 Workstations Maintenance and Service Guide

Heading Option Description
Restore from Removable Storage Device—Restores the workstation configuration
from a USB device or other storage media.
Default Setup Provides these options:
Save Current Settings as Default—Saves the current settings as default settings for
the next operation.
Restore Factory Settings as Default—Restores the factory settings as the default
settings for the next operation.
Apply Defaults
and Exit
Restores the default settings defined in Default Setup.
Ignore Changes
and Exit
Exits workstation setup without applying or saving changes.
Save Changes
and Exit
Saves changes to system configuration and exits the workstation setup.
Storage Device
Configuration
Lists installed non-SCSI storage devices (except SATA devices) and provides options for
obtaining specific information about each device:
CD-ROM SATA0—Shows the ODD default settings.
Default Values (SATA defaults)—
Translation Mode—Enables the BIOS to determine the translation mode used
to configure a formatted SATA or USB mass storage device. This prevents you
from needing to know how the mass storage device was formatted. Options are
Automatic, Bit Shift, LBA Assisted, User (Cylinders, Heads, Sectors), and Off.
Automatic is the default.
Ordinarily, you should not change the translation mode selected by the BIOS. If
the selected translation mode is not compatible with the translation mode that
was active when the drive was partitioned and formatted, the data on the disk
is inaccessible.
Storage Options Provides these options:
Removable Media Boot—Enables and disables the ability to start the workstation
from removable media.
SATA Mode—Sets the SATA emulation mode with the following options:
RAID + AHCI—The controller operates in AHCI emulation mode, which
supports AHCI protocol and executes RAID OPROMs. This emulation mode is
the default and offers the best performance and most functionality.
AHCI—The controller operates in AHCI emulation mode, which supports AHCI
protocol.
IDE—Offers standard SATA supports (four ports only).
Serial-ATA Controller—Enhanced, Compatable, or Disabled. The default is
Enhanced. This option is only available when in IDE-mode.
Boot Order Enables you to configure the boot, diskette drive, and hard disk drive orders by physically
reordering the menu entries. The following is the default boot order presented in the
menu:
EFI Boot Sources
USB Floppy/CD
USB Hard Drive
ATAPI CD/DVD Drive
Computer Setup (F10) Utility 51