HP Z220 SFF, Z220 CMT, Z420, Z620, and Z820 Workstations Maintenance and Service Guide

Heading Option Description
Save Changes
and Exit
Saves changes to system configuration and exits the computer setup.
Storage Device Configuration Lists installed storage devices and provides specific information about each
device:
●
Hard Disk—Provides information about the hard disk drives.
●
AHCI-HDD/SDD—Use the ACHI mode.
●
CD-ROM—Provides information about the optical disk drives.
Storage Options Provides these options:
●
eSATA Port—Displays the internal SATA port(s) that are configured to
operate as eSATA. Changing this to None provisions the port(s) as internal
SATA.
●
SATA Emulation—Sets the SATA emulation mode with the following options:
◦
RAID + AHCI—Both the RAID and AHCI OPROMs execute. This
emulation mode is the default and offers the best performance and
highest functionality.
◦
IDE—Offers standard SATA support. Some higher-numbered SATA
ports may not be available in this mode.
◦
AHCI—Only the AHCI OPROM executes.
●
Removable Media Boot (Enabled/Disabled)—Enabling allows the workstation
to boot from removable media, such as a USB flash drive.
●
Max eSATA Speed—Configures eSATA port speeds:
◦
Gen 2 (3.0 Gbps)
◦
Gen 1 (1.5 Gbps)
DPS Self-test Select a drive—Lets you execute self-tests on SATA hard drives capable of
performing Drive Protection System (DPS) self-tests.
NOTE: This selection appears only when the system has one or more drives
capable of performing the DPS self-tests.
Boot Order Lets you configure the boot order by physically reordering the menu entries. The
default boot order is:
●
UEFI Boot Sources
◦
USB Floppy/CD
◦
USB Hard Drive
◦
ATAPI CD/DVD Drive
●
Legacy Boot Sources
◦
ATAPI CD/DVD Drive
◦
USB Floppy/CD
◦
Hard Drive
◦
Network Controller
You can take the following actions:
●
Press Enter to drag a device with the arrow keys to a preferred place, then
press Enter again to drop the device in place.
●
Press F5 to remove the device from consideration as a bootable device.
44 Chapter 2 System management